| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| radius dish question http://www-.luthiersforum.com/forum/viewtopic.php?f=10102&t=9413 |
Page 1 of 1 |
| Author: | Philip Perdue [ Mon Nov 20, 2006 6:24 pm ] |
| Post subject: | |
I’m not sure how deep the actually cut is on a radius dish. Could they be made from 24” round 1” white pine? Thanks Philip |
|
| Author: | Rod True [ Mon Nov 20, 2006 6:57 pm ] |
| Post subject: | |
Phil, Check out this link for a recent discussion on ploting the radius for sanding jigs. I think the reason that plywood or MDF is typically used for this jig is because they are very stable and tend not to warp or twist. I would think that the pine would warp or twist or crack on you, but don't take me word for it. That's just my thought, nothing scientific. |
|
| Author: | Tom Morici [ Mon Nov 20, 2006 7:15 pm ] |
| Post subject: | |
The depth of a 15' radius on a 24" dish .4 or 13/32 25' radius on a 24" dish .24 as Rod stated, warp or twist could be a issue. I would be surprised, if it didn't twist. Tom |
|
| Author: | Philip Perdue [ Mon Nov 20, 2006 8:50 pm ] |
| Post subject: | |
Thanks |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|